Festo SPC200 Mode D'emploi page 15

3 Fitting
Fit the axis interface as close as possible to the relevant
drive. The length of the cable to the measuring system
should be approx. 300 mm.
The axis interface type SPC−AIF−... must be fitted on a flat
surface.
Fasten the axis interface with at least 3 M4 screws.
S
The axis interfaces can be fitted vertically. Separate sup
port brackets type
ary here.
1
3
1
Fastening holes for horizontal
mounting
2
Angled plug
Festo SPC−AIF−... 0506b English
(accessories) are necess
SPC−HBW−SET
3
Additional support bracket
(accessory) for fitting with
vertical mounting
2
15