Sunny Health & Fitness SF-RW5713 Mode D'emploi page 9

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY (877-907-
8669).
STEP 4:
NOTE: Move the Seat (No. 36) to the front of the
Slide Rail (No. 3) before assembly to prevent it
from gliding down during assembly.
Attach the Slide Rail (No. 3) to the Main Frame
(No. 1) using 4 Washers (No. 71), 4 Screws
(No. 60), and 4 Flat Screws (No. 58). Insert all
8 screws partially into the holes first, and then
tighten with Allen Wrench (No. 74).
STEP 5:
Connect the link wires of Inductor (No. 47) with
2 Sensor Wires (No. 93).
Attach Sensor Stand (No. 5) to Main Frame
(No. 1) using 4 Washers (No. 71) and 4 Screws
(No. 60). Tighten with Allen Wrench (No. 74).
If you are sitting on the seat, the arrow sticker on
the Sensor Stand (No. 5) must be pointing
towards you. That means the Sensor Stand
(No. 5) is installed in the correct direction.
STEP 6:
Connect 2 Sensor Wires (No. 93) with the link
wires of Meter (No. 46).
Attach Meter (No. 46) to Sensor Stand (No. 5)
using 1 Bolt (No. 63), 2 Washers (No. 71), and
1 Nylon Lock Nut (No. 56). Tighten with Allen
Wrench (No. 74) and Spanner (No. 75).
Make sure it is not too tight to adjust the angle of
Meter (No. 46).
The assembly is complete!
8

Publicité

Table des Matières
loading

Table des Matières