Installation; Preparing For Installation - Inventum AKI6015ZWA Manuel D'utilisation

• Attention:
The carbon filters and plasma filter are not included. You need to order these separately.
4

Installation

SAFETY INSTRUCTIONS FOR INSTALLATION
• Install the appliance with two people.
• Wear safety gloves. The appliance has sharp edges.
• The distance between the lowest point of the appliance and a gas hob must be a minimum of 75 cm. For an
electrical, ceramic or induction hob, the minimum distance must be 65 cm.
• Always obey the manual of the cooker or the gas hob if that manual states a larger distance.
• Warning:
• Risk of electric shock
• Always use the screws or fasteners that are stated in the installation instructions. Failure to do so
can result in electric shock.
UNPACKING
1. Remove the packaging.
2. Examine the appliance for damage.
3. Make sure that the voltage is the same as on the type plate.

PREPARING FOR INSTALLATION

1. Mark the wall/ kitchen cabinet from the middle of the hob. Make sure that you keep the
minimum distance between the hob and the appliance into account plus the height of the
appliance (A).
2. Determine the position of the hose. Saw out an opening (F) for the hose.
Note:
The diameter of the hose is 150 mm. The opening must be 10 mm larger than the hose (160 mm).
3. Attach the hose to the extraction duct and allow it to hang down.
4. Open the cover of the appliance and remove the grease filter.
By removing the grease filter before hand, it will be easier to fixate the appliance to the kitchen cabinet.
PREPARING THE INSTALLATION OF THE HOSE FOR EXTRACTION MODE
The hose can be installed either via the wall or via the ceiling.
Preparing the installation of the hose via the wall
1. Drill a hole (A) in the wall with a diameter of 160 mm.
Preparing the installation of the hose via the ceiling
1. Drill a hole (A) in the ceiling with a diameter of 160 mm.
2. Make sure that the hole is positioned a minimum of 100 mm (B) from the wall.
30 • English
(Figure 4)
(Figure 5)
(Figure 6)