Mitsubishi Electric PAC-SC30GRA Manuel D'installation page 8

• After the B [TEST RUN] switch has been pressed twice in succession the
from flashing to lit continuously (The overall status lamp lights up). The
during test run.
• The smallest address of indoor unit of the smallest number group is displayed on the collective operation setting
screen (above).
• To check the liquid pipe temperature for the indoor units registered in each group, select the indoor unit for which
the liquid pipe temperature is to be checked using the C [External Timer]
• and all select icons for the registered groups flash during test run.
TEST RUN
4 Close the upper panel (setup complete).
* The screen continues when setting up individual groups. The collective operation monitor screen appears when
setting up collectively. Ensure that the upper panel is fully closed.
5 Test run complete.
The test run setup in 3 is completed after two hours and operation is then halted (the test run display is extinguished).
• Operation is halted only for the groups for which test run has been performed.
• Operation is halted for all groups in a batch.
Test run may be halted as follows irrespective of the remaining time (air-conditioning units halted).
• Press the J [Collective ON/OFF] switch • Press the I
switch.
Test run is terminated only for the relevant group when the K [ON/OFF by Group] switch is pressed.
and time remaining display changes
ON
and group select display flash
TEST RUN
switch.
switch • Press the K [ON/OFF by Group]
ON/OFF