Aqua Medic cool control Mode D'emploi page 4

Digital temperature measuring and regulating unit for controlling 12/24 V fans
With the purchase of this digital measuring and regulating unit, you have selected a top quality product. It has
been specifically designed for aquaristic purposes. With this unit, you can continuously measure and control the
temperature of the water in your aquarium.
1. Included in shipment
Temperature controller cool control with touch display for controlling 12 or 24 volt DC fans with barrel connector
(5.5 mm x 2.1 mm). The Aqua Medic temperature controller cool control is equipped with a saltwater-proof
temperature sensor as standard and is ready for connection. Without power supply and fan.
2. Safety instructions
- When working in the aquarium, always disconnect all units from the power supply system before putting your
hands into the water. Connect all units to the mains via a residual current device with a maximum residual
current of 30 mA.
- Suitable for indoor use only.
- Protect the power supply and controller from moisture, splash and condensate.
- Not suitable as a toy for children.
3. Fan
A 12 or 24 V DC fan with a barrel connector (5.5 mm x 2.1 mm) can be connected. The power pack of the fan is
connected to the corresponding connection on the controller (Fig. 1, No. 5) as a power supply, the fan is connected
to the power output of the controller (Fig. 1, No. 6).
4. Description of the front panel
Fig. 1: cool control
1. Fan power
2. Nominal value + set
3. Actual value
4. Temperature sensor
5. Power supply 12 or 24 V DC. Socket for barrel connector (5.5 mm x 2.1 mm)
6. Connection for fan with a barrel connector (5.5 mm x 2.1 mm)
7. Arrow key to adjust the parameter
8. Arrow key to adjust the parameter
9. „On/Off" button
Operation Manual ENG
4