Operation Tips - Electrolux EXP09HSECI Manuel D'utilisation

16 www.electrolux.com
7.3 Drainage
During the Heat and dry mode, you need
to connect the drain hose to the drain
outlet in the back of the unit to drain the
condensate from the unit� Otherwise, the
unit may not function normally and display
show "P1"�
A� Discharge into a drain that is lower than
the unit�
B� The unit have a pump to drain the
condensate�
Fig. 23
If necessary you can extend the drain hose
by adapting the drain hose adpator in the
end of the drain hose, then use a 8-9mm
hose to extend�(Fig� 24)
Connect a 8-9mm hose here
to extend the draining hose
Fig. 24
During cooling mode, please replace the
rubber stopper to the hose connector to
reach the maximum performance�

7.4 Operation Tips

Now that you have mastered the operating
procedure, here are more features in your
control that you should become familiar
with�
• The "Cool" circuit has an automatic 3
minutes time delayed start if the unit is
turned off and on quickly� This prevents
overheating of the compressor and
possible circuit breaker tripping� The fan
will continue to run during this time�
• Temperature can be set between 16 °C
and 32 °C�
• The control is capable of displaying
temperature in degrees Fahrenheit or
degrees Celsius� To convert from one to
the other and back, press and hold the
"TEMP" Up ( + ) and Down ( - ) buttons
together for 3 seconds�
• There is a 2-Second delay for the
compressor shutting down when
selecting Fan� This is to cover the
possibility of having to roll through to
select another mode�
• After a power outage, the unit will
memorize the last setting and return the
unit to the same setting once power is
restored�
• Indoor operating temperature range for
this product is 16 °C to 35 °C�
• During normal operation, the unit's
display will show room temperature
but when the room temperature is over
37°C the display will show "HI"�
• After 60 seconds of control inactivity the
display and indicator lights will turn off�
Press any button on the control panel
or remote control and the display will
resume�