14 www.electrolux.com
4. Replace the battery and reinstall the
inside cover and back cover�
Battery Type: RG15D/E-ELL (Rated
Voltage:3VDC)
WARNING!
Please use the battery
appropriately
Chemical Burn Hazard� Keep batteries
1.
away from children�
Be sure the batteries are inserted
2.
properly�
7. OPERATING INSTRUCTIONS
Some of the following instructions
can only be used by using the
Control Panel�
7.1 Usage of the Control Panel
Heating mode (on some models)
In this mode the exhaust adaptor hose
MUST be used�
1. Press the "Modes" button until the
"Heat" indicator is lit�
2. Press the " - " & " + " Temp buttons for
desired setting�
3. Press the "fan speed" button for desired
fan speed�
4. Connected drain hose� See 7�3
Drainage section�
Cooling mode
In this mode the exhaust adaptor hose
MUST be used�
Do not use batteries other than the
3.
type specified�
Do not use old batteries with new
4.
ones �
Do not dispose of batteries in fire�
5.
Batteries may explode or leak�
Fig. 22
6.
The cells shall be disposed of
properly, including keeping them away
from children and even used cells may
cause injury�
To prevent damage, remove the
7.
batteries when not being used for a
long time�
8.
This device complies with Part 15 of
the FCC Rules� Operation is subject
to the following two conditions: (1)
This device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation�
1. Press the "Modes" button until the
"Cool" indicator lights�
2. Press the " - " & " + " Temp buttons for
desired setting�
3. Press the "Fan speed" button for
desired fan speed�
Fan mode
In this mode there is no need to use the
exhaust hose or drainage hose�
1. Press the "Modes" button until the "Fan"
indicator is lit�
2. Press the "Fan speed" button to choose
the desired fan speed�
3. The fan will run at the selected speed
and the display will show the room
temperature�
It is not necessary to use the
drainage hose in the "cool" mode�