Technical Service; Replacement Parts Information - Campbell Hausfeld CP5211 Instructions D'utilisation Et Manuel De Pièces

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Operation (Continued)

1. Engage the trigger safety latch.

2. Turn the unit off.

3. Shut off the water supply.

4. Disengage the trigger safety latch and trigger the gun to

relieve pressure.

5. Re-engage the trigger safety latch.

6. When checking or repairing unit, remove the wall outlet

plug from the wall.

7. Before overnight storage, long term storage, or

transporting unit, disconnect the water supply.

SHUTDOWN

1. Be sure all detergent is flushed from system.

2. Turn the motor OFF.

3 Turn the water supply OFF.

4. After the motor and water supply are turned off, trigger

the gun to depressurize the system.

NEVER turn the water supply off before

turning the engine/motor off. Serious

damage could occur to the pump and/or engine/motor.

NEVER disconnect the high pressure

discharge hose from the machine while

the system is pressurized. To depressurize, turn engine/motor

off, turn water supply off and squeeze gun trigger 2-3 times.

5. After each use, wipe all surfaces of the pressure washer

with a clean, damp cloth.

STORAGE

•

Do not store the pressure washer outdoors.

•

Do not store the pressure washer where it might freeze

unless it has been properly winterized.

WINTERIZING INSTRUCTIONS

1. Disconnect the high pressure hose from the pump.

2. Insert a 12 inch to 14 inch piece of garden hose into the

pump inlet.

3. Place a funnel in the other end of the garden hose.

Read the manufacturer's instructions for

safe handling and disposal of RV

antifreeze.

4. Pour approximately 6 oz. of RV antifreeze into the funnel.

5. Jog the On/Off Switch briefly until the RV antifreeze

comes out of the pump outlet.

6. Disconnect the high pressure hose from the gun and drain

the hose. Hold the gun and lance in a vertical position

and squeeze the trigger to drain the water out.

TIPS FOR EXTENDING THE LIFE OF YOUR PRESSURE

WASHER

1. Never operate the unit without water.

2. Your pressure washer is not meant to pump hot water.

Never connect your pressure washer to a hot water supply

as it will significantly reduce the life of the pump.

3. Running the unit for more than one minute without

spraying water causes heat to build up in the pump.

Running the unit without spraying water will shorten the

life of the pump components.

Maintenance

Observe regular maintenance intervals to ensure maximum

performance and life from the pressure washer. Refer to the

schedule for recommended maintenance. If you operate the

pressure washer in dusty conditions, perform maintenance

checks more often.

MAINTENANCE SCHEDULE

Daily

TECHNICAL AND CONSUMER INFORMATION

HORIZONTAL ORIENTED PRESSURE WASHERS

Pump Oil Capacity

XJV

4DX and 4DNX

Pump Detergent Suction

Water to detergent ratio

Water Supply Requirements

Minimum inlet pressure

Maximum inlet pressure

Maximum inlet temperature

Minimum inlet flow rate

Inlet garden hose size

Maximum inlet garden hose

length