Operating Instructions - Midea NTH20-17BR Guide D'utilisation

OPERATING INSTRUCTIONS

Check before turning on the device.
1. Check if the mains cable is in good condition.
2. The product adopts 220-240V AC power supply. Before use, confirm if the rated
current of the power socket meets the local requirements with safe grounding
device; otherwise, replace it with the qualified socket.
Installing the appliance
Install the appliance on a flat and stable surface.
This product can be used vertically (control panel facing upwards) or horizontally
(control panel facing left). In the event of a horizontal installation, make sure the air
intake and exhaust grilles are completely clear.
Vertical position
Starting the appliance
Turn the power switch to "I" position. Press the ON/OFF button (or the ON/OFF
button on the remote control) to start working. The device supplies air at high power
after starting and the display will show the temperature setting of 35°C.
Function setting
Repeatedly press the Mode button for cycling the heater through high - low - fan - ECO
mode - high.
Fan mode: the appliance does not heat and ventilates ambient air.
ECO mode: the appliance is running on economical heating power and automatically
adjusts the temperature to keep it constant in the room.
Temperature setting
During operation, press the + or - button to set the temperature value in the
range of 5 - 35°C. When the room temperature reaches the set temperature, the
display flashes for 10s and the device stops heating. When in standby mode the
temperature is lower than the set temperature, the device starts heating again.
Horizontal position
15