Midea NTH20-17BR Guide D'utilisation page 19

Timer
Off-timer
During operation, press the TIMER button to enter the off-timer (0 - 24 hours).
Then repeatedly press the + button to increase the off-time by 1 hour each time.
Press the - button to decrease the off-time by 1 hour each time.
On-timer
In standby mode, press the TIMER button to enter the on-timer (0 - 24 hours). Then
press the + button to increase the on-time by 1 hour each time. Press the - button to
decrease the on-time by 1 hour each time.
Oscillation
During operation, press the Swing button to enter swing mode. Press this button
again to turn off the swing function. In stop mode, the oscillation also stops.
Memory function
When you turn off the appliance normally, then turn on it again, it will start to work
by the setting of last time. If the appliance is power off, it will start to work by the
factory default setting when you restart it. Default temperature is 35°C.
Auto display off
During operation, after 1 minute without pressing any button, the display
automatically switches off; only heating logo is lit. Press and hold the + and -
buttons for 2 seconds, to turn off the display. Press and hold the buttons again for
2 seconds, to turn the display on again.
Temperature sensor short circuit, open circuit protection function
In any mode, temperature sensor short circuit protection, room temperature will
display E1 or E2 and constantly flash; all buttons are invalid. The buzzer beeps
10 times.
Safety protection
During start with the room temperature TH above 50°C, all output is closed. The
display shows "FF" and flashes 1 time per second for 75 seconds. All buttons are
invalid except the ON/OFF button.
Remote control
Use instructions remote control: the button functions are basically the same as on
the operating panel.
This heater cannot achieve accurate temperature control of the environment, and
thus cannot be used for the storage of items, animals and plants.
16