Safety Instructions And General Warnings; General Warnings; Safety Warnings - MS Schippers Fancontrol FRQ Manuel D'instructions

1 Safety instructions and general warnings

Read, understand and carefully follow all warnings and instructions of MS Schippers to use our products
safely. These warnings and instructions can be found on the equipment, in manuals, in brochures, on our
website or by contacting us. The selection and application of MS Schippers products remains the
responsibility of the installer or end user of the equipment. MS Schippers accepts no responsibility for the
way its products are applied. All MS Schippers products must be delivered to the end user with appropriate
warnings and instructions regarding safe use and operation. MS Schippers does not accept any liability for
personal injury, material damage, losses or claims as a result of incorrect application of its products.

1.1 General Warnings

 Read and understand all warnings and instructions provided by MS Schippers before
installing, using or maintaining any of our products.
 All work may only be carried out by qualified personnel.
 The product may only be placed, used or stored in places that are inaccessible to children.
 Handle the product with care; impacts, shocks or falls, even from a low height, can damage
the product.
 Do not expose the product to direct sunlight, high heat or cold.
 Always check all settings after installation to make sure they are working correctly.
 Do not use running water to clean your computer. The computer is splashproof, not
waterproof!

1.2 Safety warnings

 Do not wear metal or conductive materials, such as jewellery (necklaces, bracelets, rings,
etc.) when installing or servicing electrical parts or components.
 Always switch off the power before opening the enclosure.
 Never remove components or wires from electronic boards when the device is turned on.
 Use the correct mains voltage.
 Make sure that all clamp screws are correctly tightened.
 Always use cable glands when installing cables in the controller.
 After installation, unused cable glands or blind holes must be sealed to prevent water, dust
and other substances from entering the regulator.
 If you have reason to believe that the device can no longer be used safely, disconnect it
immediately and ensure that it is not operated inadvertently.
MS FANCONTROL FRQ manual
EN- MS Fancontrol FRQ
⚠ WARNING
⚠ WARNING
Page 3
6