Legal Information; Warranty Terms And Conditions - FIBARO Heat Controller Mode D'emploi

Specifications
Thermostatic Head:
Power supply:
Supported charger:
Radio protocol:
Radio frequency band:
Operating temperature:
Maximum water
temperature:
Supported valves:
Dimensions (D x L):
EU directives compliance:
Temperature Sensor (optional):
Power supply:
Radio frequency band:
Operating temperature:
Dimensions (D x H):
EU directives compliance:

Legal information

Simplified EU declaration of conformity:
Hereby, Fibar Group S.A. declares that
the device is in compliance with Direc-
tive 2014/53/EU. The full text of the EU
declaration of conformity is available
at the following internet address:
www.manuals.fibaro.com
WEEE Directive Compliance:
Device labelled with this symbol should not
be disposed with other household wastes.
It shall be handed over to the applicable
collection point for the recycling of waste
electrical and electronic equipment.
3.7V Li-Poly battery pack
(non-replaceable)
micro-USB 5V, min. 0.5A
Z-Wave (S2-enabled)
868 MHz band
0-40°C
M30 x 1.5, Danfoss RTD-N,
Danfoss RA-N
56 x 74 mm
56 x 87 mm (with
adapter)
RED 2014/53/EU
RoHS 2011/65/EU
3.0V CR2032 battery
(included)
2.4 GHz
0-40°C
38 x 12 mm
RED 2014/53/EU
RoHS 2011/65/EU
Warnings
Using batteries other than specified may result in
explosion. Dispose of properly, observing environ-
mental protection rules.
This product is not a toy. Keep away from children and
animals! CR2032 coin cells are harmful if swallowed!

Warranty terms and conditions

90°C
1. FIBAR GROUP S.A. with its registered office in
Poznan, ul. Lotnicza 1, 60-421 Poznań, entered
into the Register of Entrepreneurs of the National
Court Register maintained by the District Court for
Poznań-Nowe Miasto and Wilda in Poznań, VIII Com-
mercial Division of the National Court Register (KRS)
under number: 553265, NIP 7811858097, REGON:
301595664, share capital PLN 1,182,100 paid in full,
other contact information is available at: www.fiba-
ro.com (hereinafter "the Manufacturer") guarantees
that the device sold (hereinaftr: "the Device" is free
from material and manufacturing defects.
2. The Manufacturer shall be responsible for mal-
functioning of the Device resulting from physical
defects inherent in the Device that cause its oper-
ation to be incompatible with the specifications
within the period of:
- 24 months from the date of purchase by the con-
sumer,
- 12 months from the date of purchase by a business
customer (the consumer and business customer are
further collectively referred to as "Customer").
3. The Manufacturer shall remove any defects re-
vealed during the guarantee period, free of charge,
by repairing or replacing (at the sole discretion of
the Manufacturer) the defective components of the
Device with new or regenerated components. The
manufacturer reserves the right to replace the entire
Device with a new or regenerated device. The Manu-
facturer shall not refund money paid for the device.
4. Under special circumstances, the Manufacturer
may replace the Device with a different device most
similar in technical characteristics.
5. Only the holder of a valid guaranty document
shall be entitled to make claims under guarantee.
6. Before making a complaint, the Manufacturer
recommends using the telephone or online support
available at https://www.fibaro.com/support/.
4