Safety And General Information; Product Description - Blackhawk Automotive BH6033 Instructions D'utilisation Et Manuel De Pièces

SAFETY AND GENERAL INFORMATION

Save these instructions. For your safety, read, understand, and follow the information provided with and on this
device before using. The owner and/or operator shall have an understanding of the device, its operating characteristics
and safety operating instructions before operating the equipment. The owner and/or operator shall be aware that use
and repair of this product may require special skills and knowledge. Instructions and safety information shall be read
to and discussed with the operator in the operator's native language, making sure that the operator comprehends
their contents, before use of this equipment is authorized. If any doubt exists as to the safe and proper use of this
device, remove from service immediately.
Inspect before each use. Do not use if abnormal conditions such as cracked welds, damaged, loose or missing
parts are noted. Any equipment that appears damaged in any way, is found to be worn, or operates abnormally shall
be removed from service until repaired. If the equipment has been or is suspected to have been subjected to an
abnormal load or shock, immediately discontinue use until inspected by a factory authorized repair facility (contact
distributor or manufacturer for list of authorized repair facilities). It is recommended that an annual inspection be
made by an authorized repair facility. Labels and Operator's Manuals are available from the manufacturer.

PRODUCT DESCRIPTION

Service Jack is designed to lift, but not support, one end of a vehicle. Immediately after lifting, loads must be supported
by a pair of appropriately rated jack stands. This Fast Lift Service Jack has a unique feature that provides fast, no
load lifts to the jacking point, at which time it lifts in approximately 0.75 ~ 2" increments.
WARNING: Do not use hydraulic jack as stand-alone device. After lifting, immediately support the lifted vehicle
!
with a pair of appropriately rated jack stands.
Jack Stands are designed to support rated capacity, partial vehicle loads consisting of one end of a vehicle. Use
as a matched pair to support one end of a vehicle only.
!
WARNING: Use only on areas of the vehicle as specified by the vehicle manufacturer. Use only on vehicles
whose support points are compatible with the saddle of the jack stand. Incompatibility may result in structural
damage to the vehicle and/or jack stand. Structural damage to either may result in sudden and unexpected
loss of load height.
Lifting Arm
Handle Sleeve
Pump
Piston
Release
Valve
Caster
Figure 1 - Service Jack Components
Saddle
Front Wheel
Handle
2
Saddle
Press Tab
Figure 2 - Jack Stand Components
Ratchet Bar
Locking Handle
Lock Pin
Locking Pawl
Base
Frame