Display Indicators - Zephyr Anzio Island ZAZ-M90CS Guide D'utilisation, D'entretien Et D'installation

3 LIGHTS BUTTON
- Lights are two levels, High and Low.
- From off, press one time for High. Press again for Low. Press again to power lights off.

4 DISPLAY INDICATORS

Mesh Filter Clean Reminder (always enabled)
- After 30 hours of fan usage, the
clean the mesh filters.
- To reset: With hood off: hold the
confirming the 30 hour timer has been reset.
Charcoal Filter Replace Indicator (disabled by default, must be enabled if recirculating hood)
- To enable Charcoal Filter Replacement Reminder:
- With hood off, hold
will illuminate for three seconds confirming the Charcoal Filter Replace Reminder is enabled.
- To disable Charcoal Filter Replacement Reminder:
- With hood off, hold
will blink two times confirming the Charcoal Filter Replace Reminder is disabled.
- After 120 hours of fan usage the
replacment.
- To reset: With hood off, hold the
confirming the 120 hour timer has been reset.
5 LIGHTED GLASS BUTTON (MODEL ZLC ONLY)
- Press to cycle glass color from White, Blue, Amber and Off.
- Press and hold for 3 seconds to activate demo mode. While in demo mode each color will gradually
change every 10 seconds.
- Pressing to power off the LED lights will also power off the lighted glass.
button indicator will begin to slowly blink indicating it is time to
button for three seconds. All LED indicators will blink two times
button and button simultaneously for two seconds. All LED indicators
button and button simultaneously for two seconds. All LED indicators
button will slowly blink indicating the charcoal filters need
button for two seconds. All LED indicators will blink two times
16
www.zephyronline.com