How To Treat - Beurer Tria Laser Precision LAS 50 Instructions D'utilisation

HOW TO TREAT

1. TURN ON THE LASER, UNLOCK IT AND SET
THE TREATMENT LEVEL (SEE PAGES 12-13)
2. TOUCH THE TREATMENT WINDOW TO
THE SKIN. WHEN YOU HEAR A SINGLE
BEEP IMMEDIATELY LIFT THE DEVICE
AND MOVE TO STEP 3
•
If you do not hear a beep within a few
seconds, make sure that the treatment
window is flat against your skin. The laser
will only pulse when the entire window is
touching your skin.
• If you hear a buzzing tone instead of a beep,
you lifted the device from the skin before
the pulse was over. It is normal for time
between beeps to lengthen as you progress
through each treatment. This should not
affect your results.
NOTE: It is normal for the cooling fan to turn
on and emit warm air through the bottom
vent as soon as you unlock your device.
You can continue treatment while this is
happening and do not need to wait for the
fan to turn off before treating the next area.
3. PLACE THE LASER BACK ON THE
SKIN SO THAT IT OVERLAPS THE
PREVIOUS AREA
• Each time you reposition the treatment
window, move it about half the distance of
the window (about 1/4 inch or 5 mm) in a
stamping motion.
• This creates an overlapping pattern in the
treatment area, which ensures you cover all
the hair follicles. This works out to about 25
laser pulses per square inch or 40 pulses per
10 square cm.
Tria Beauty 14
GB
15