Automatic Icemaker - Cafe CZS22M Manuel Du Propriétaire

Automatic Icemaker

Not all features are on all models.
Automatic Icemaker
The icemaker will produce seven cubes per cycle—
approximately 100–130 cubes in a 24-hour period,
temperature, number of door openings and other use
conditions.
If the refrigerator is operated before the water connection
is made to the icemaker, set the power switch in the
OFF position.
When the refrigerator has been connected to the water
supply, set the power switch to the ON position.
The icemaker will fill with water when it cools to 15°F
(–10°C). A newly installed refrigerator may take 12 to 24
hours to begin making ice cubes.
fills with water.
Throw away the first few batches of ice to allow the
water line to clear.
Be sure nothing interferes with the sweep of the feeler
arm.
When the bin fills to the level of the feeler arm, the
icemaker will stop producing ice. It is normal for several
cubes to be joined together.
If ice is not used frequently, old ice cubes will become
cloudy, taste stale and shrink.
CAUTION
Avoid contact with the moving parts of
the ejector mechanism, or with the heating element
(located on the bottom of the ice maker) that releases
the cubes. Do not place fingers or hands on the
automatic ice making mechanism while the refrigerator is
plugged in.
Special note about dispenser models:
tilted out as shown in the illustrations, and it will hold
itself up while you take ice out or turn the icemaker
power switch on and off. Be sure to put the bin back in
place before closing the door.
To restore your ice level from an empty bucket
stage, the following steps are recommended:
1. 12 hours after the first batch of ice has fallen into the
bin, dispense 3 to 4 cubes.
10
Icemaker
Feeler Arm
2. After an additional 6 hours, dispense 3 to 4 cubes
again.
These steps will restore your ice level in the shortest
amount of time.
NOTE:
In homes with lower than average water pressure, you
may hear the icemaker cycle multiple times when making
one batch of ice.
Accessing Ice and Reaching the Power
Switch on Dispenser Models
There are two types of ice storage bins on
dispenser models. One has a shelf above the bin, the
other does not.
Special note for models with tilt-out ice bin:
tilted out as shown in the illustrations, and it will hold
itself up while you take ice out or turn the icemaker
power switch on and off. Be sure to put the bin back in
place before closing the door.
NOTE: In order to take full advantage of the tilt-out ice
bin, only store items on the shelf below the ice bin that
are no taller than the lowest point on the bin.
To access ice, pull the bin
forward.
To reach the power switch,
pull the shelf straight out.
Always be sure to replace the
shelf.
Shelf
Removing Ice Bin
CAUTION
The ice bin is heavy when full.
Set the power switch to
the OFF position before
removing the bin.
When replacing the bin, be
sure to press it firmly into
place. If it does not go all
the way back, remove it and
rotate the drive mechanism
1/4 turn. Then push the bin
back again.
Shelf
Ice Bin
(dispenser models)
Rotate
Drive
Mechanism
Dispenser Models only
49-1000209 Rev. 0