Logan 401-1 Manuel D'instructions page 6

Instruction Manual
Resquaring the Guiderail
1. Remove mat guide (Fig. 17).
2. Add slip sheet (white side up). Raise guiderail.
3. Loosen screws 1 & 2 one full turn. Loosen screw. 3 only 1/2
turn so guiderail moveable but not loose on hinge. (Fig. 18).
4. Position carpenter square up against squaring bar and under
guiderail (Fig. 19).
5. Hold carpenter square firmly against squaring bar (Fig. 20).
6. Adjust guiderail parallel to carpenter square edge.
7. Raise guiderail & retighten screws.
8. Lower guiderail & recheck parallel
9. Replace mat guide & reparallel mat guide.
Re-parallel Mat Guide
Tools Needed: Phillips Screwdriver, Ruler
To re-parallel the Mat Guide, first determine that the Mat Guide
is out of parallel by doing a parallel test.
Parallel Test:
Lock the Mat Guide at the 2" mark on the scale (Fig. 21).
1.
2. Place a scrap piece of matboard under the Guide
Rail and up against the Mat Guide at the far end of
the machine.
3. Using a pencil, mark a line across the matboard.
4. Slide the mat all the way down near where you are
standing keeping under the Guide Rail.
5. Mark another line across the matboard.
6. The piece of matboard should now appear to only have
one single line across it. If the two lines drawn do not
line up with each other, the Mat Guide needs to be
re-paralleled.
To Re-parallel:
1. Release the Mat Guide.
2. Use a Phillips head screwdriver to loosen the four screws
on either side of the black knobs one turn.
Fig. 21
2 in
5 cm
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 847-526-5515 LoganGraphic.com
Artist Classic Mat Cutter
Fig. 17
Fig. 18
Fig. 19
Fig. 20
Mat Guide
3. 2.
Model 401-1
1.
6