Logan 401-1 Manuel D'instructions page 3

Instruction Manual
MAT CUTTING BLADES ARE SHARP
Blade Installation - Model 702-1 Bevel Cutter
1. Loosen blade retaining screw enough to allow blade holder to tilt back
(Fig. 2). Loosen the blade holding knob.
2. Remove one blade from the package of five.
NOTE: Because the blades are packed with a small amount of oil, they may stick
together. Be certain that only one blade is being inserted into the blade slot.
Slide blade, sharp edge down, fully into blade holder (Fig. 3).
3.
NOTE: The hole in the blade is not designed to line up with the blade screw.
4. Tighten blade screw.
5. Tilt blade holder down, allowing tip of blade to enter into the blade slot
6. Retighten retaining screw (Fig. 4).
Blade Installation - Model 500 Mat Knife
1. Remove blade knob and blade cover.
2. Align blade hole over bolt thread. Be sure sharp edge of blade is facing
down.
Reassemble blade cover and blade knob. (Fig. 5)
3.
NOTE: Adjust blade to 8-ply (fully extended), standard 4-ply mat board (middle
setting) or safety (fully retracted).
Mat Guide Assembly
1. Loosen each mat guide knob three full turns.
2. Hold mat guide at ends with your thumbs on the loosened knobs with
raised edge facing guiderail and evenly drop mat guide into channels.
3. Slide to adjust and tighten knobs to lock mat guide (Fig. 6).
Fig. 6
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 847-526-5515 LoganGraphic.com
Artist Classic Mat Cutter
CAUTION!!
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Model 401-1
3