Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Instruction Manual
With left hand, depress the Anti-Crawl Pin and firmly pivot the Blade Holder down into the mat (Fig 13).
8.
NOTE: It is essential to keep even downward pressure on the Blade Holder as you cut.
9.
Release the Anti-Crawl Pin and pull the cutting head towards you until start & stop line lines
up with bottom pencil line (Fig. 14).
10. Rotate the blade holder back up to the neutral position, turn the mat 1/4 to the right. Complete
this for the remaining three sides.
Bevel Cutting Mat Openings Using One Rail Stop (most popular)
EXAMPLE: Cutting a mat with a 2" border.
1.
Set the Mat Guide to the desired border width. For example, for a 2" border, align the front of
the Mat Guide at the 2" mark and tighten the Black Knobs (Fig. 9).
2.
Install or slide rail stop over guiderail scale and set at 2".
3.
Place the mat to be cut into the machine colored side down with the Slip Sheet underneath
and lower the Guide Rail (Fig. 10).
4.
Using a pencil, mark a line along the full length of the matboard using the Guide Rail as a
guide (Fig. 11). Turn the mat 1/4 turn to the right before cutting.
5.
Attach the 702-1 Bevel Cutter to the Guide Rail by fitting the black nylon guides over the
raised edge of the channel.
6.
Position the cutter so the start & stop line lines up with the marked line closest to the top of
the machine (Fig. 12).
NOTE: Extra start & stop lines are for reference to increase or decrease overcuts.
7.
With left hand, depress the Anti-Crawl Pin and firmly pivot the Blade Holder down into the mat (Fig 13).
NOTE: It is essential to keep even downward pressure on the Blade Holder as you cut.
Release the Anti-Crawl Pin and pull the cutting head towards you until you reach the stop (Fig. 15).
8.
9.
Rotate the blade holder back up to the neutral position, turn the mat 1/4 to the right and use
the cut line in the back of the matboard to start your next cut. Complete this for
remaining three sides.
Adjustments
Bevel blade depth adjustment
•
Increase depth to increase overcuts - Decrease depth to reduce overcuts
1.
Hold the 702-1 Bevel Cutter upside down in your hand with the blade activated in the
cutting position.
2.
Measure the exposed amount with a ruler at the same angle as the blade. For standard
thickness mat board (4 ply/1.4mm) only 1/8" of blade should be seen (Fig. 16).
3.
Turn blade depth screw (clockwise) to decrease blade depth and (counterclockwise) to
increase depth.
NOTE: Always have blade depth set so that Slip Sheet is only slightly scored.
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 847-526-5515 LoganGraphic.com
Artist Classic Mat Cutter
Model 401-1
Fig. 13
Fig. 14
Fig. 15
Fig. 16
1/8 in
3 mm
CAUTION!!
MAT CUTTING BLADES ARE SHARP
5
Publicité
Table des Matières
