Storage; Disposal; Trouble Shooting - Zipper Maschinen ZI-MOS145JAK Manuel D'utilisation

14.2 Storage

If the machine will be stored longer than 30 days:
 Let the machine cool down.
 Empty Tank completely, avoid fuel spillage.
 Remove and clean thread head and cutter blade
 Fit the blade guard
 Clean the machine and dry
 Store in a dry, out of reach of children place, well packaged (protection against cuts)

14.3 Disposal

Do not dispose the machine, machine components fuel and oil in residual waste.
Contact your local authorities for information regarding the available disposal options.
When you buy at your local dealer for a replacement unit, the latter is obliged to
exchange your old.
15

TROUBLE SHOOTING

Trouble
Engine does not start
Engine starts and is stalled
immediately
Machine works with
interruptions
Smoke
Machine does not work with
full performance
Blade rotates at idling
Blade rotates but has no
power
Bad cuts
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the problem.
ZIPPER MASCHINEN GmbH
ZI-MOS145JAK
Possible cause
 Incorrect starting sequence
 Dirty air filter
 No fuel supply
 Fault in the fuel line
 Engine flooded.
 Spark plug connector not
placed on.
 No ignition spark
 Incorrect idle adjustment
 Carburetor incorrectly
adjusted
 Spark plug fouled
 Incorrect fuel mixture
(2-stroke engine)
 Carburetor incorrectly
adjusted
 Machine overloaded
 Dirty air filter
 Carburetor incorrectly
adjusted
 Idle speed too high
 Choke is ON
 Foreign material wrapped,
grass around the sheet
 Long grass
 Blunt saw blade
www.Zipper-Maschinen.at
 Observe the correct starting
sequence
 Clean/replace air filter
 Refuel
 Check the fuel line for kinks or
damages
 Screw off, clean and dry the spark
plug. Then pull the cranking rope
several times and reinstall the spark
plug
 Place on the spark plug connector
 Clean/replace spark plug
 Check ignition cable
 Contact customer service
 Contact customer service
 Clean/replace spark plug
 Check spark plug connector
 Use correct fuel mixture
 Contact customer service
 Too much pressure
 Cutting material too tough
 Clean/replace air filter
 Contact customer service
 Adjust a lower idle speed
 Set Choke to OFF
 Shut machine off, wait until cutter
stands still, remove the winded up
material
 Remove material
 Sharpen or replace saw blade
NOTICE
TROUBLE SHOOTING
Solution
26