Burkert 7615 Manuel D'utilisation page 6

DANGER!
Danger – high pressure!
• Before disconnecting any lines and valves, turn off the pressure
and vent the lines.
Risk of electric shock!
• Before reaching into the device or equipment, switch off the power
supply and secure to prevent reactivation!
• Observe applicable accident prevention and safety regulations
for electrical equipment!
CAUTION!
Risk of burns/risk of fire if used continuously through hot
device surface!
• Keep the device away from highly flammable substances and
media and do not touch with bare hands.
General hazardous situations.
To prevent injury, ensure the following:
• Ensure that the system cannot be activated unintentionally.
• Do not place a physical load on the housing (e.g. by placing objects
on it or standing on it).
• Do not make any external alterations to the housing of the device.
Do not paint housing parts or screws.
6
english
Type 7615
Authorized use
• Installation and repair work may be carried out by authorized
technicians only and with the appropriate tools.
• After an interruption in the electrical or pneumatic supply,
ensure that the process is restarted in a defined or controlled
manner.
• The device must only be operated when in a perfect condition
and in consideration of the operating instructions.
• The general rules of technology must be observed for applica-
tion planning and operation of the device.
NOTE!
Electrostatic sensitive components/modules!
• The device contains electronic components which react sensitively
to electrostatic discharge (ESD). Contact with electrostatically
charged persons or objects are hazardous to these components.
In the worst case scenario, they will be destroyed immediately or
will fail after start-up.
• Observe the requirements in accordance with DIN EN 61340-5-1/5-2
to minimize or avoid the possibility of damage caused by sudden
electrostatic discharge!
• Also, ensure that you do not touch electronic components when
the power supply voltage is present!