Brandson 304577 Manuel D'instructions page 41

9. You can see the following status of the Wi-Fi symbol on the weather
station display:
Connection symbol
8.1 Time Server Connection Status
1. When the weather station is connected to the Internet, it tries to
establish a connection to the Internet time server to obtain the UTC
time.
2. The time is automatically synchronised at 12:00 am and 12:00 pm
every day with the Internet time server.
8.2 Alarm setting (alarm time + high/low alarms)
1. Press the "ALARM" button in normal mode to display the "HI" (High)
alarms.
2. When the alarm time is displayed, press the "ALARM" button again
to display the "LO" (Low) alarms.
3. To change the alarm settings, press and hold the "ALARM" button for
about 5 seconds in normal mode. You hear a beep.
4. You can adjust the values using the buttons "WIND (+)" and "PRES-
SURE (-)" and confirm your input using the "SET" button. You can
disable or enable the alarm by pressing the "ALARM" button. An en-
abled alarm in the corresponding settings field is symbolically shown
using a bell symbol (time alarm) and in the individual sections with
"HI" or "LO".
Note: Press the "ALARM" button in the alarm setting if you want to ena-
ble the alarm.
English
Description
Stable: The weather station is connected to the
Wi-Fi router
Flashes: Access point mode active.
41