Possible Malfunctions - Bartscher SNACK 132260 Mode D'emploi

o Remove regularly the limestone deposits forming in the basin to avoid excessive
energy consumption and reduced performance of the device. For this purpose use a
solution of water with vinegar (3:1 ratio) or a commercially available descaling agent.
Observe the instructions of manufacturers of such agents.
o After descaling, rinse the basin with clean water a few times.

7. Possible Malfunctions

In case of malfunction, disconnect the device from its power source. Before contacting
the service or sales agent, verify - based on the table below - whether it is possible to
eliminate disruption in operation.
Problem
The device is connec-
ted to an electricity
source, turned on,
temperature set, but
the green control light
does not come on
and the device does
not heat up.
The orange control
light comes on, but the
temperature in the
device does not rise.
The green standby
light comes on, but the
orange operation
control light does not
come on even though
the temperature has
been set.
Cause
• Plug improperly inserted
• Circuit breaker activated
• Circuit box installed
improperly
• No contact in microswitch
• Overheating protection
mechanism activated
• Damaged temperature
regulator (overheating
protection)
• The heating element
terminal is damaged
• Heating element is
damaged
• The set temperature has
been reached
• Damaged temperature dial
• Damaged control light
Solution
• Remove the plug and
reinsert it correctly
• Check the circuit breaker,
check the device by
connecting it to another
socket
• Check placement of the
circuit box
• Contact a sales agent
• Press the RESET button
on the circuit box
• Contact a sales agent
• Contact a sales agent
• Contact a sales agent
• Check the device's
operation after changing
the temperature setting
• Contact a sales agent
• Contact a sales agent
- 31 -