Installation And Operation; Installation - Bartscher SNACK 132260 Mode D'emploi

5. Installation and operation

5.1 Installation

Positioning
•
Unpack the device and remove all packing material. Remove the protective film from
the device.
CAUTION!
Never remove the rating plate and any warning signs from the device.
•
Place the device on top of an even, stable, dry, and water-resistant surface which
supports the weight of the device and is not heat sensitive.
•
Never place the device on a flammable surface.
•
If the device is placed near walls or furniture, they must be resistant to a temperature
of 60 ° C. If the wall contains flammable materials, they must be covered with a heat-
absorbent layer.
•
Ensure there is sufficient air circulation around the device. Leave 10 cm at the sides
and 30 cm from the ceiling or cupboards. Leave sufficient space for personnel
operating the device.
•
Place the device under a fume hood to ensure all fumes are removed when the
device is in operation.
•
Do not locate the device in places with high ambient humidity. Excessive moisture
can damage the device.
•
Never place the device in humid or wet areas.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.
Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid specification should
be compared with that of the device (see rating plate). Connect the device only
in case of compliance!
Connect the device only to properly installed single socket with
protective terminal.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
- 27 -