Cleaning And Descaling - Bartscher SNACK 132260 Mode D'emploi

•
After the device automatically shuts down to prevent
overheating, it can only be reactivated by using the
RESET button located at the bottom of the circuit box.
•
First, leave the device to cool, then remove the
plastic cover over the RESET button by turning it
counterclockwise, press the button, then turn the
cover clockwise to replace it.
•
After performing the above steps, the device can
be used again.

6. Cleaning and descaling

CAUTION!
Disconnect the unit from the power supply (unplug!) before cleaning.
The unit is not designed to be rinsed with running water.
Do not use a pressure washer to clean the device!
Be careful and do not let the water into the unit.
o Clean the device regularly.
o Turn the device off before cleaning (turn the ON/OFF switch to "O"), remove
the plug from its socket, then leave to cool.
o Remove the basket and heating element shield from the basin.
o Carefully lift the circuit box and separate from the device, then clean with a moist,
soft cloth. Ensure that no water gets into the circuitry, as the device can cause
injury or be damaged.
o Use the lowered handles to remove the basin with water from the housing,
then empty it.
o Wash the basket and basin in warm water with a mild cleaning agent. Rinse with
clean water, then dry the cleaned elements.
o Clean the interior and exterior of the device's housing with a soft, moist cloth.
o Never use cleaning agents containing bleach, chlorine or alcohol, nor abrasive
substances that could damage the device's surface.
o Dry the device thoroughly with a soft, dry cloth.
- 30 -
RESET-button