This product is for domestic use ONLY and should not be used commercially or for contract purposes.
Installation
•
As shown in Figure A, put Part 8 through the hole of Part 9 making sure the end of Part 8 with welded plate is downward. At
the bottom of Part 9, put Part 11 through Part 10, and then screw it onto part 8.
•
Install Part 7 on top of Par 8. Pullout Part 3 upward from inside of of Part 5. Screw Part 4 clockwise to lock it. Then install Part
5 on Part 7.
•
Insert the end with a whole of Part 3 to the hole of Part 1. Then fiix it with Screw (Part 12) by aligning the screw to the whole of
Part 3.
•
Adjust the unit to a desired height, then fix it by turning Part 4 clockwise.
•
Put the power supply cord into the hole of Part 13.
•
As shown in Figure C, the tilting of the herter is adjustable for 25º. Adjust it to a desired angle when necessary.
www.sunred.nl