Midwest Ferret Nation 181 Mode D'emploi page 4

9.
Attach the two Side Panels by inserting the pegs into
the holes between the Door and Back Panels. Be sure
the cut-outs on the bottom go around the protruding
wires of the Bottom Floor Panel Grid. Insert the
protruding tabs at the top of the panels into the
protruding openings in the Door and Back Panels to
lock the panels together.
10.
Locate the Top Panel Grid (D). Lay the Top Panel
Grid on the top of the assembled Cage. Line up the
panel so the pegs in the corner line up with the
openings in the corners of the assembled cage. To
secure the Top Panel, swing the Swivel Locks around
the wires of the Top Panel till tight in place. It may
be easier to open doors and swing Swivel Lock from
inside of cage. Open the doors by pinching the
knobs on the doors together. Once Swivel Lock is in
place, tighten Flat Head Screw.
11.
Insert the Bottom Pan (G) in the bottom of the unit.
12.
Locate the Shelf (H). With the doors in the top unit
open, tilt the Shelf down and insert the end of the
hook in the middle holes on the right side of the top
unit. Lift the Shelf up and let hook fall into place.
13.
Attach the Ramp Clips to the ramp by inserting the
two hooks on the ramp into the holes on the Ramp
Clips. The hooks on the ramp and the hooks on the
Ramp Clips should be facing the same direction.
14.
Attach the ramp to the Shelf by hooking the Ramp
Clips to the wire on the Shelf as illustrated. The lip
of the plastic Shelf pan will cover the Ramp Clips.
Note: The Shelves, in conjunction with the Side
Panels, can be positioned at 3 different levels on
either side of the cage.
9
13
12
Shelf
10
14
Side
Panel
Attach Ramp Clips
to Shelf Wire