Midwest Ferret Nation 181 Mode D'emploi page 3

4. Locate the 4 Casters (L- 2 locking, 2 non-locking).
Insert the post of the caster into the pre-inserted
sleeve in the bottom of the Base. Be sure that the 2
locking casters are on one long side, and the 2
non-locking casters are on the opposite side. To
fully secure the casters in the sleeves, push the
caster in by hand or push down on the frame of the
stand with your hand or foot. (Note: The side with
both locking casters will now become the "front" of
the cage.)
5.
Locate the Door Panel (A) and insert the pegs into
the outer-most holes of the Base Assembly. The
Door Panel should be inserted on the side of the
stand that has the two locking casters. Be sure the
door locking knobs face outward.
6.
Locate the Bottom Floor Panel Grid (F) and insert
the protruding wires into the corresponding holes of
the Door Panel. Be sure the wires that run front to
back on the grid are on the top.
7.
Locate the Back Panel (B) and insert one peg in one
of the back, outer-most holes.
protruding rectangular openings are facing inward.
While slightly lifting the Bottom Floor Panel Grid,
swing the other end of the back panel around,
aligning the protruding wires of the Grid with the
holes in the Back Panel. When they are all lined up
and inserted, put the peg in the outer-most hole.
8.
Locate the two Side Panels (C) two Swivel Locks (O),
and two Flat Head Screws (N). Using the Phillips
Head Screwdriver (P) and flat head screws, attach
one Swivel Lock to each of the Side Panels. (Do not
tighten all the way.)
7
6
Be sure the
4
Back
8
Front
5