Possible Causes - babymoov Nutribaby+ Notice D'utilisation

DESCALING
When the Nutribaby + / XL has been used for a certain period of time, mineral deposits may form on the heating unit and damage
it. Thus, the icon (2.1.) will be displayed on the control panel.
You should descale the water tank regularly (every 50 cycles), pouring 100 ml of hot water and 100 ml of white vinegar. Let it
sit for one or two hours (or more if necessary), without plugging in the apparatus. Pour off the mixture and wipe of inside of the
tank and the heating unit with a wet cloth.
Once the operation is completed, hold down OK for 5 seconds to make the icon
Limescale may also be removed using limescale removers designed for food products (citric acid based).
N.B.: 50 cycles is an average estimate. Descaling may need to be carried out more often if the water used has a high mineral
content ("hard water").
PROBLEMS
The blending jug is not working
The symbol is lit up
The symbol is lit up
The product stops before
finishing the cooking, sterilising
or heating cycle
The blending unit has suddenly
stopped
NUTRIBABY + / NUTRIBABY + XL • Instructions for use

POSSIBLE CAUSES

The connector is not pulled out and
connected to the blending unit.
The blades are not turning.
The blending jug lid is not
positioned correctly.
The symbol lights up automatically
after 50 heating cycles.
The steaming unit has run out of water.
Limescale build-up.
The fuse or heat protection is activated
(this applies to most models).
(2.1.) disappear.
SOLUTION
Pull out the connector and connect it to the
blending unit by placing it on top.
Contact the after-sales service. We may need
to exchange your blending unit.
Check whether the lid is positioned correctly
on the blending jug. If the lid is positioned
correctly but blending will still not start, please
contact our customer service department.
Press the OK button for 5 seconds. If the
ymbol stays on, you will need to RESET.
To reset, press the 2 arrows and the ON/OFF
button at the same time.
Press the OK button for 5 seconds and add
water. If the symbol stays on, you will need
to RESET.
To reset, press the 2 arrows and the ON/OFF
button at the same time.
See the 'CARE AND CLEANING' section in
the instruction manual for how to descale the
product using water and vinegar.
Let the product cool down for a few moments.
Add liquid to the blending jug and blend again.
If the product still does not work after that,
please contact our after-sales service.
EN
17