Gram KS Serie Mode D'emploi page 38

GB
factory-set to run at optimum temperatures
and can be operated with the TEMP key
5 .
By pressing the key and holding it down,
you will in a moment or two see the actual
temperature setting on the display. This
setting will remain on the display for about
3 seconds. By keeping the key pressed
down it is possible to change the setting.
See below.
Changing the
temperature
Press TEMP and keep it held down. You
will in a moment or two see the actual set-
ting on the display and the small lamps will
light up, one after the other, along the
scale. When the end of the scale is rea-
ched all lamps will go out for an instant
before starting to light up again. Release
the TEMP key when the lamp opposite to
the temperature you require lights up. The
refrigerator will now run at this new setting.
Switching off for
cleaning/defrosting
Press the TEMP key as under "Changing
the temperature" and release the key the
moment that all lamps go out - before they
light up again. This switches off the refrige-
ration function and the refrigerator can be
cleaned. It will still be possible to read off
the actual temperature for about 2 hours,
then this function too will cease automati-
cally.
Start the refrigerator again by setting a
temperature. See "Changing the tempera-
ture".
Power failure
After power failure the cabinet starts auto-
matically. As soon as power is restored, the
38
cabinet runs and the alarm is activated
(see section on alarm).
Alarm
The alarm activates if the power fails, or if
the cabinet temperature remains 6°C high-
er than the setting for more than two hours.
The alarm will continue even after the tem-
perature has returned to normal, just to tell
you that something went wrong.
Alarm on starting
Your new GRAM model has not been con-
nected to a power supply since it was test-
ed at the factory, therefore the electronic
control "thinks" there has been a power
failure when you connect up the refrigera-
tor in your kitchen and thus the alarm acti-
vates accordingly.
Deactivating the alarm
Press the TEMP key and keep it held
down. After a moment or two the display
will show the set temperature. To deactiva-
te the alarm, release the key as soon as
the setting appears.
Emergency programme
If the sensor fails, an emergency program-
me takes over temperature control until the
installer/service technician arrives.
Short-lived tempera-
ture deviations
Short-lived temperature deviations are nor-
mal. They occur when:
- the refrigerator is filled with fresh items,
- the door is left open longer than usual,
- the evaporator defrosts.
Some of the lamps on the temperature
scale light up when the temperature devi-
ates. Such deviations do not affect items of
food stored in the refrigerator and the tem-
perature quickly returns to normal.