Gas Connection; Electrical Connection - Summit GC2BGL Mode D'emploi

Gas Connection

Natural Gas and Propane Gas
Natural gas installations require the connection of a gas regulator to the cooktop.
You will find this regulator among the accessories supplied with the appliance.
Assemble the regulator (noting the direction of gas flow) and transition pieces
(supplied) in accordance with the figure below.
The transition piece on the supply side of the regulator must be provided by the
installer. Unions compatible with the hose fittings must be used and connections
tested for gas leaks.
Be sure that the supply connection point is accessible with the appliance
installed.
WARNING: Be sure the hose assembly is restrained from accidental contact with
the flue or flue outlet of an under-counter oven.

Electrical Connection

The electrical connections of the appliance must be carried out in compliance
with local standards and provisions.
Before connecting the appliance, check that:
1. The electrical capacity of the main electrical supply and current sockets suit
the maximum power rating of the appliance. (See the data label attached to
the bottom of the cooktop.)
2. The socket or system has an efficient ground connection in compliance with
local standards and provisions. The manufacturer is not responsible for failure
to comply with these provisions.
The maximum gas supply
pressure (in accordance with the
inlet pressure rating of the
pressure regulator supplied).
The gas supply pressure for
testing the regulator setting the
pressure shall be at least 1 in.
water column (249 Pa) above the
specified manifold pressure).
7