bonavi BNV-ST-0002 Manuel D'utilisation page 43

Removing Carry Cot Cover (for washing)
1.
Open the velcro and pull the frame wire
out of the fixtures on both sides.
WARNING: To avoid injuries, ensure that your
child is kept away whenever unfolding or folding
this product.
order:
4.
zip
Open the zipper, located at the footend, to fully
remove the carry cot cover from the frame.
Detach the ABS board through the anticipated
screws. Use two crosshead screwdrivers. Turn
around one screw clockwise and fixate the
opposite screw through the second
x4
screwdriver.
WARNING: All loose screws, washers and
spacers need to be safely stored. Failure to do
so might occure in a choking hazard.
43
2.
Lift the frame wire until an upright position
(90°) is reached on both sides and pull both
wires out of the respective holders.
WARNING: Do not store the frame wires close
to your child to prevent injuries.
5.
To reassemble the carry cot follow
steps 1 - 4 in reverse.
WARNING: Please ensure all
screws, washers and spacers are
tightly fastened. Failure to do so
may result in a choking hazard
and instability of the carry cot.
remove!