Connecting The Appliance; Operation; Preparing For Operation; Setting The Clock - Inventum IMC3834GT Manuel D'utilisation

Warning:
Two persons are required to install the appliance.
Caution:
Make sure that the mains cable does not get jammed during installation or is placed on top of the
appliance.
Caution:
Do not cover the opening between the kitchen furniture and the top of the appliance. The opening is
required for ventilation.
Note:
It is possible to connect the appliance to the mains supply before positioning the appliance.
Note:
Do not hold or carry the appliance by the door handle. The door handle cannot hold the weight of the
appliance and may break off.
Procedure
1. Put the appliance (A) in the center of the kitchen furniture. Making sure the appliance is in the
centre.
2. Open the door (D) of the appliance.
3. Install the appliance in the kitchen furniture. Use the screws (C).
4. Install the covers (B).
5. Close the door.
6. Connect the appliance. Refer to section

CONNECTING THE APPLIANCE

1. Make sure that the voltage in your home corresponds with the voltage of the appliance.
2. Make sure that the electrical system in your home is supplied with a 16 Amp fuse.
Note:
If you replace the supplied mains cable, make sure that the new mains cable has a minimum core
cross section of 2.5 mm2 and a length of 1.5 m. If you use a mains cable that is too short, you cannot
connect the appliance and position it in the kitchen furniture before connecting the appliance to the
mains socket.
3. Use the supplied mains cable to connect the appliance to the mains socket.
After connecting, the clock shows '00:00' and you will hear a sound signal.
5

Operation

PREPARING FOR OPERATION

1. Clean the appliance using a damp cloth.
2. Clean the accessories. Use warm water and a mild cleaning agent.
3. Rinse the accessories thoroughly with water.
4. Dry the appliance and the accessories.

SETTING THE CLOCK

1. Push the clock/kitchen timer button. The clock display shows '00:00' and the value for hours flashes.
2. Move the slider or push the up/down button to adjust the hours. Note: the value must be between 0 and 23.
3. Push the clock/kitchen timer button again to confirm.
4. Move the slider or push the up/down button to adjust the minutes. Note: the value must be between 0 and 59.
32 • English
'Connecting the appliance' .
(Figure 4)