X-lite X-602 Sécurité Et Instructions D'utilisation page 13

1.8 Fit the visor in the helmet.
WARNING!!!
- Make sure that the system has been assembled properly by pulling up and down the-
visor.
- Scratched visors and inner visors can cause reduced visibility and must therefore
bechanged.
2 DISASSEMBLY
2.1 Remove the visor equipped with inner visor.
2.2 Widen the visor: the inner visor will come off automatically.
MAINTENANCE AND CLEANING
Remove the inner visor from the visor. Using a damp and soft cloth, gently clean it with
neutral liquid soap. Remove the soap under running water.
Dry the inner visor with dry and lukewarm air without wiping it.
To keep the features of the inner visor in good conditions over time, let the helmet dry in a
ventilated and dry place with the visor open after use.
Keep it away from heat sources and store it in a dark place.
Do not use solvents or chemical products.
• WIND PROTECTOR
This accessory allows improved helmet performance under certain conditions of use.
The Wind Protector prevents annoying infiltration of air under the chin area. See Fig. 9 for
assembling and disassembling.
ATTENTION!!!
The Wind Protector is easily removable. You can check the correct assembling of this
accessory by pulling it gently towards the inner part of the helmet with your thumb and
forefinger. If it moves, repeat the assembling operations.
13