5. After the above settings are completed, press the ◄ button to exit and make sure the
Alarm is turned on. You will see the Alarm icon appeared on the display if it is activated.
You can set the timer to let the radio goes standby after the selected
time elapsed in the range of 15 minutes to 180 minutes.
Press
button on the remote control to set the timer.
You will see the icon appeared on the display if the timer is set.
Here you will find the complete settings / options available to configure your own unit.
Wi-Fi Network
Add / Remove AP
Add AP - It will scan out a list of routers around.
Remove AP - If you have already added a router and want to remove it, choose this
option. Note - Always bring the unit within 2 meters of the Wi-Fi router for setup.
AP: [ ]
If you have added more than one routers on the radio and want to switch to another one,
select this option to change.
Signal
This is to show the strength of the Wi-Fi Signal of the Wi-Fi router as received by the
radio. Usually signal levels lower than -70dBm is at weaker level and if it affects the
reception of your radio, you may need to optimize the router location or check any
problem of the router itself.
IP
The IP is set Dynamic by default. Select to change Fixed IP according to your network
condition.
DNS
The DNS is set Dynamic by default. Select to change <Fixed> DNS according to your
network condition.
Wi-Fi Channels
Not all of the Wi-Fi channels are available in every country. There may be variation between
different countries. Therefore it is necessary to choose the Wi-Fi channels to ensure the Wi-Fi
performs satisfactory.
We have already set the channels according to the requirement in different countries. Choose
the country you are staying from the list to get the correct channel.
The Europe/United Kingdom is set by default, press "OK" on the Remote control or push the
"Dial/OK" knob to edit the country selection.
SLEEP TIMER
CONFIGURATION
10
IR45SW / English Instruction Manual