Matrix E30 Mode D'emploi page 21

A Open HARDWARE FOR STEP 1.
1
B Remove 4 PRE-INSTALLED SCREWS (5) and
TOP CAP COVER (6)from MAIN FRAME (4).
C Carefully pull the CABLE (1) through the
CONSOLE MAST (2) using the LEAD WIRE
(3) located inside the CONSOLE MAST (2).
D Attach CONSOLE MAST (2) to MAIN
FRAME (4) using 4 BOLTS (A) and 4 FLAT
WASHERS (B). Tighten to 40 Nm / 29 lb-ft.
E Attach the TOP CAP COVER (6) to the MAIN
FRAME (4) using 4 PRE-INSTALLED SCREWS (5).
F Attach the CONSOLE MAST BOOT (7) to the
TOP CAP COVER (6) by snapping it into place.
7 2
1
4
40
MXR20_AG_E30_E50_r1_0_B.indd 40-41 MXR20_AG_E30_E50_r1_0_B.indd 40-41
Hardware For Step 1
A Open HARDWARE FOR STEP 2.
2
B Slide LOWER DUAL ACTION ARM
Description Qty
(8) onto the CONSOLE MAST (2)
A Bolt 4
B Flat Washer 4
C Attach using 1 FLAT WASHER
(E), 1 HANDLEBAR CAP (9), 1
Note: Be careful not to pinch
FLAT WASHER (F), 1 SPRING
any wires while attaching the
WASHER (G) and 1 BOLT (H).
upper assembly.
Tighten to 40 Nm / 29 lb-ft.
D Repeat on other side.
3
1
A
B
5
2 8
6
5
Hardware For Step 3
A Open HARDWARE FOR STEP 3.
3
B Attach the LINK ARM (9) to the HANDLEBAR
Description Qty
(8) using 1 BOLT (I). 1 NUT (J).
E Flat Washer (25 mm) 2
F Flat Washer (19 mm) 2
C Repeat on other side.
G Spring Washer 2
H Bolt 2
Hardware For Step 3
Description
I Bolt
J Nut
E F H
9 G
E50
A Open HARDWARE FOR STEP 4.
4
B Connect the CABLES (1) to the CONSOLE
(13) and carefully tuck the excess
cable into the CONSOLE MAST (2).
Attach the CONSOLE (13) to the
C
CONSOLE MAST (2) using 4 BOLTS (K).
D Attach PEDAL (14) to LINK ARM (9) using
4 SCREWS (L). Repeat on other side.*
Qty
2
2
8
L 14
9
J
I
E30 SHOWN
Hardware For Step 4
Description Qty
K Bolt 4
L Screw 8
Note: Be careful not to pinch any
wires while attaching the console.
13
1
2
K
E50
*
15
L
14
Attach PEDAL (14) to
LINK ARM (9) using 4
SCREWS (L). Snap PEDAL
INSERT (15) into pedal.
Repeat on other side.
41
9/28/20 11:50 AM 9/28/20 11:50 AM