Serial Number Location; Need Help - Matrix E30 Mode D'emploi

ASSEMBLY
WARNING!
There are several areas during the assembly process that special
attention must be paid. It is very important to follow the assembly
instructions correctly and to make sure all parts are firmly tightened. If
the assembly instructions are not followed correctly, the equipment could
have parts that are not tightened and will seem loose and may cause
irritating noises. To prevent damage to the equipment, the assembly
instructions must be reviewed and corrective actions should be taken.

SERIAL NUMBER LOCATION

Before proceeding, find your elliptical's serial number located on a barcode
sticker and enter it in the space provided below.
SERIAL NUMBER
MODEL NAME
E30 E50 MATRIX ELLIPTICAL
F F
* Use the information above when calling for service.
38
MXR20_AG_E30_E50_r1_0_B.indd 38-39 MXR20_AG_E30_E50_r1_0_B.indd 38-39
UNPACKING IMPORTANT NOTES
Unpack the equipment where you During each assembly step, ensure that ALL nuts
will be using it. Place the carton and bolts are in place and partially threaded.
on a level flat surface. Never open
Several parts have been pre-lubricated to aid in assembly
box when it is on its side.
and usage. Please do not wipe this off. If you have difficulty,
a light application of lithium grease is recommended.
TOOLS INCLUDED: PARTS INCLUDED:
F 5 mm Allen Wrench F 1 Elliptical Frame
F 6 mm Allen Wrench F 1 Console Mast
F 13/17 mm Flat Wrench F 1 Console Mast Boot
F Phillips Screwdriver F 2 Handlebars
F 2 Handlebar Caps
F 2 Pedals with Inserts
F 2 Transport Handles
F 1 Power Cord
F 1 Hardware Kit
Console sold separately

NEED HELP?

If you have questions or if there are any missing parts, contact Customer Tech
Support. Contact information is located on the information card.
RESISTANCE TOGGLES
HANDLEBAR
PULSE GRIPS
WATER BOTTLE HOLDER
TOP HAND RAIL
SWING ARM
FOOT PADS
PEDAL ARM
TRANSPORT HANDLE (REMOVE BEFORE USE)
E30 SHOWN
CONSOLE
CONSOLE MAST
TOP CAP
POWER CORD SOCKET
LINK ARM
39
9/28/20 11:50 AM 9/28/20 11:50 AM