Bosch GWS Professional 660 Notice Originale page 28

Provide for sufficient dust extraction when
cutting stone.
The protection guard for cutting 14 is mounted
in the same manner as the protection guard for
grinding 7.
Cutting Guide with Dust Extraction Protection
Guard
The cutting guide with dust extraction protec-
tion guard 21 is mounted in the same manner as
the protection guard for grinding 7.
Auxiliary Handle
Operate your machine only with the auxilia-
ry handle 5.
Screw the auxiliary handle 5 on the right or left
of the machine head depending on the working
method.
Hand Guard
For operations with the rubber sanding
plate 17 or with the cup brush/wheel
brush/flap disc, always mount the hand
guard 16.
The hand guard 16 is fastened with the auxiliary
handle 5.
Mounting the Grinding Tools
Before any work on the machine itself, pull
the mains plug.
Grinding and cutting discs become very hot
while working; do not touch until they have
cooled.
Clean the grinder spindle 6 and all parts to be
mounted.
For clamping and loosening the grinding tools,
lock the grinder spindle with the spindle lock
button 1.
Actuate the spindle lock button only when
the grinder spindle is at a standstill. Other-
wise, the machine may become damaged.
Grinding/Cutting Disc
Pay attention to the dimensions of the grinding
tools. The mounting hole diameter must fit the
mounting flange without play. Do not use reduc-
ers or adapters.
Bosch Power Tools
When using diamond cutting discs, pay atten-
tion that the direction-of-rotation arrow on the
diamond cutting disc and the direction of rota-
tion of the machine (see direction-of-rotation ar-
row on the machine head) agree.
See graphics page for the mounting sequence.
To fasten the grinding/cutting disc, screw on
the clamping nut 11 and tighten with the two-
pin spanner; see Section "Quick-clamping Nut ".
After mounting the grinding tool and before
switching on, check that the grinding tool is
correctly mounted and that it can turn free-
ly. Make sure that the grinding tool does
not graze against the protection guard or
other parts.
Mounting flange for grinding
spindle M 14: An O-ring (plas-
tic part) is inserted in the
mounting flange 9 around the
centring collar. If the O-ring is
missing or is damaged, it must
in all cases be replaced (article
number 1 600 210 039) before
the mounting flange 9 is mounted.
Flap Disc
For operations with the flap disc, always
mount the hand guard 16.
Rubber Sanding Plate
For operations with the rubber sanding
plate 17, always mount the hand guard 16.
See graphics page for the mounting sequence.
Screw on the round nut 19 and tighten with the
two-pin spanner.
Cup Brush/Disc Brush
For operations with the cup brush/wheel
brush, always mount the hand guard 16.
See graphics page for the mounting sequence.
The cup brush/disc brush must be able to be
screwed onto the grinder spindle until it rests
firmly against the grinder spindle flange at the
end of the grinder spindle threads. Tighten the
cup brush/disc brush with an open-end span-
ner.
English | 29
1 619 P08 849 | (12.3.10)