BH G6755 Instructions De Montage Et Utilisation page 20

you place your feet during the exercise).
Once the lubricant has been applied you
should neither fold nor use the machine
for a few hours. This will allow the belt to
get well impregnated.
If you have any doubts, an illustrative
video is available on our YouTube
channel
(https://www.youtube.com/c/BHFitnessS
ervice/videos).
If the bottle of lubricant is missing in
the box, please ask for it before using
an inappropriate lubricant.
CAUTION: Using
supplied by BH or lack of lubrication
leads to loss of warranty.
It is very important to keep the belt
well lubricated
maintenance and to avoid expensive
damages.
It is advisable to lubricate the base of
the belt between the board and the
band depending on how often it is
used.
<6
>6
Note: This preventive
schedule is only meant for home use.
It is suggested to maintain the unit every
month for commercial use.
In aggressive environments, with high
dispersion of particles or with heavy
weight people,
should be increased accordingly.
lubricant
for its correct
Hours per week
<=7 >7
1 month 1 month
2 months 1 month
maintenance
lubrication frequency
If the belt starts to slip after lubrication,
then check the tension of the belt. To
tension the belt, take the 6mm Allen
key and with the machine set to 4km/h
turn screws (R & L) one turn in a
clockwise direction.
11 ADJUSTING THE BELT.-
CAUTION:
machine, turn it on and check that
the belt is centered. If necessary,
follow the steps below.
If your unit is not seated evenly on the
four contact points, this may cause the
belt (X) to shift sideways.
If the belt does shift to the left or right,
stop the machine.
not
BELT OFFSET TO THE RIGHT.-
This procedure is very important. Follow
these steps. In order to adjust the belt,
set the unit in motion at a speed of
4km/h. If the belt has moved to the right,
turn screw (R) on the right-hand side of
the machine a 1 4 turn clockwise. Note
the position of the belt, if after one minute
the belt is not completely centred then
repeat the operation. If you see that the
belt has moved too far over to the left
then turn the right screw back slightly in
an anticlockwise direction. Fig.11.
As soon as you have adjusted the belt
you can begin exercising again.
BELT OFFSET TO THE LEFT.-
In the event that the belt has moved to
the left, turn screw (L) on the left-hand
side of the machine a 1 4 turn clockwise.
Note the position of the belt, if after one
minute the belt is not completely centred
then repeat the operation.
If you see that the belt has moved too
far over to the right then turn the left
screw back slightly in an anticlockwise
direction. Fig.11.
20
Before using the