Back Panel; Installation Requirements - FS T5850-24S2C Guide De Démarrage Rapide

Back Panel

3 Redundant Fans

Installation Requirements

The operating temperature is maintained at 0°C-45°C, the storage temperature is maintained at
-40°C-85°C, the humidity is maintained at 10%-95%.
Power source should be removed before cleaning Network Packet Brokers. Do not use wet rags to
wipe Network Packet Brokers and clean it with liquid.
Do not place Network Packet Brokers near water or in a wet environment and prevent water or
moisture from entering Network Packet Broker chassis.
Do not place Network Packet Brokers on an unstable case or table, since the dropping would
cause serious harm to Network Packet Brokers.
Maintain good indoor ventilation and clear air holes of Network Packet Brokers.
Network Packet Brokers shall work normally under correct voltage, so make sure the operating
voltage agrees with the voltage marked on Network Packet Brokers.
To reduce the risk of electric shock, do not remove its enclosure when a Network Packet Broker is
working, and don't do so at will even if it is not powered.
Anti-static gloves must be worn when replacing interface board to prevent static electricity from
damaging veneer.
During equipment transport and installation, prevent the equipment from colliding with objects
like doors, walls, or shelves.
Do not touch unpainted metal surfaces of equipment components with wet or contaminated
gloves.
Do not place other objects on the chassis.
4
2 Hot-swappable Power Supplies
ID SY S
CO N
ET H
S5 8 5 0 -2
4 S2 Q