Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
Pitch Adjustment
(See Figure 8)
4.
Loosen PITCH adjustment locking screw using a #2 Phillips
screwdriver.
5.
Turn PITCH micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
6.
Tighten PITCH adjustment locking screw using a #2 Phillips
screwdriver.
5
(projector example)
Figure 8
Roll Adjustment
(See Figure 9)
7.
Loosen ROLL adjustment locking screw using a #2 Phillips
screwdriver.
8.
Turn ROLL micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
9.
Tighten ROLL adjustment locking screw using a #2 Phillips
screwdriver.
7
9
(projector example)
Figure 9
4
6
5
8
8
ELPMBPRH
9
Publicité
Table des Matières
