Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
14
Problem
Illuminations of the knob
EN
and switch work fine but
side/rear burner ignition
does not work
Illumination and Side/Rear
burner Ignition work fine
but I can't ignite the side
or rear burner even when
sparking noise occurs
The knob and switch lights
blink eight times with 0.5
seconds intervals and then
turn off.
www.napoleon.com
Possible Causes
The ignitor switch doesn't work properly
The ignitor block doesn't work properly
The gap between electrodes is too big or too
small
The batteries are low
Solution
Replace the ignitor switch if the switch light
illuminates when you turn the light switch on
Check the switch connection inside the control
panel if there's no illumination on the switch
when you turn it on
Replace the ignitor block if the ignitor switch
illuminates and sparking noise can't be heard
Adjust the gap between two prongs of the
side burner electrode when the side burner
doesn't ignite
Adjust the gap between the electrode and
the rear burner when the rear burner doesn't
ignite
Replace the batteries
N415-0522 SEP 25.20
Publicité
Table des Matières
