Introduction; Packaging - CLAS PE 2001 Mode D'emploi

PE 2001
2 COLUMNS ASYMETRIC POST LIFT 4T

INTRODUCTION

All safety precautions that have been attached to the lift during the design and manufacture
phase, combined with an adequate training and proper use of the equipment, allow for a better
degree of safety. It is forbidden to operate using the lift without reading and viewing the following
manual.
Check the transcribed data on the motor nameplate and the nameplate data for the lift, only
qualified electricians are authorized to make electrical connections.
It is forbidden to use equipment for lifting vehicles with a capacity exceeding 4000 KG.
Read carefully the warnings contained in the user manual.
The Company declares no responsibility for damages due to the improper use of the lift.
The manufacturer reserves the right to make changes to the operating and maintenance
manual if there are technological improvements.
TRANSPORTATION :
Packages can be lifted and moved using forklifts, cranes or overhead cranes. In the case
of slinging, in order to avoid dangerous handling, a second person must be present to
ensure that the cargo is handled safely. When checking the goods received, if missing parts,
defects or damage to the packaging or goods due to transport are found, it is necessary to
ensure that the damaged packaging is examined and, in accordance with the packing list,
to check the actual condition of the damaged goods or missing parts or components and
immediately inform the person in charge or the carrier.

PACKAGING

Standard Schema:
1) Main column with its components (selection and control commands), secondary column with
its components.
2) the hydraulic unit and components.
Standard equipment: 2 packages in total.
28