Safety Recommendations; Riding Instructions - Yedoo Wzoom New Notice De Montage

Safety recommendations

The scooter in its basic configuration is designed for riding in
daylight in areas designated for sport and recreation, ideally on
a smooth, dry surface.
For riding on roads and in the dark you must equip the
scooter with additional safety devices (lights, reflectors etc.)
in compliance with applicable regulations in your country.
Observe traffic rules, principles of safe riding and wear
personal protective equipment (helmet, bike gloves, knee and
elbow pads, boots, etc.).
Before each ride check your brakes and the overall technical
condition of the scooter. Inflate the tyres to the recommended
maximum pressure (see the side of the tyre). Do not exceed
its capacity. The scooter is designed only for one rider. Do not
overload the scooter. The scooter is not intended for jumps or
acrobatic riding.
All components designed to decrease speed (brake pads, rims,
tyres, etc.) get hot while in use. Do not touch any of the parts
until they have cooled down!

Riding instructions

Keep both hands on handlebars while riding. While you use
one leg for taking off, use your second leg for standing on the
footrest. Alternate your legs regularly. Press the brake levers on
the handlebars to apply the brakes. Caution: Sudden braking
may cause a fall.
Maintenance
Proper maintenance will improve safety and extend the life of
your scooter. Therefore, tighten the screw connections, check
the tyre pressures and lubricate moving parts (bearings in the
wheels and handlebars, brake lever pins, brake mechanism
pivot points, brake cables, etc.) regularly.
Make sure that the applied lubricant does not get on the rims
and brake pads. Grease reduces their effect! If that happens,
degrease soiled areas with, for example, technical gasoline.
Check the tyre tread depth regularly and replace the tyres with
new ones with the same parameters if necessary. If the scooter
is not ready to be used, clearly mark it as such.
Check the condition of self-locking nuts regularly (if they
become loose spontaneously, replace them with new ones).
Regularly check the wheel spokes, uneven tension of the wires
can cause cracking or decentralization of the wheels.
The product complies with the relevant EU standards
(EN 14619) and it also received certificates of quality and safety
by a leading Czech testing institute (Strojírenský zkušební
ústav, s. p.).
EN
The manufacturer and importer in the EU is INTREA – PIKO, s.r.o.,
Sasanková 2657/2, 106 00 Prague 10, Czech Republic,
www.yedoo.eu.
Exercise of rights arising from
defective performance
General provisions
Content, scope and duration of the purchaser's rights arising
from defective performance is governed by the applicable laws
of the Czech Republic, in particular the relevant regulations
of the Civil Code (Act No. 89/2012 Coll.) and the Consumer
Protection Act (Act No. 634/1992 Coll.). The rights of the
purchaser within these regulations are not affected by this
document or the information contained in it.
Period for exercising of rights arising from defective
performance
The purchaser can apply the right from defects in newly bought
Yedoo scooter (hereinafter goods) within a period of 24 months
from the day of receipt. If the buyer defines the defect of the
goods legitimately, the period for exercising rights arising from
defective performance is suspended for the time during which
the buyer cannot use the goods.
Specifications of application of rights arising from the
defective performance
Rights arising from the defective performance are applied to
the dealer where the goods were purchased (see details below).
We recommend to submit this document, proof of purchase
and a complete scooter free from any impurities when applying
the rights from defects.
The seller will issue a written confirmation of the exercise of
rights arising from defective performance or a confirmation
of repair.
Specification of rights of defective performance
When assembling the scooter the instructions given in the
installation manual must be followed. The scooter must be used
exclusively for the purpose for which it was made. The scooter
must be stored and maintained according to the provided
manufacturer's instructions. The manufacturer's liability does
not apply to defects caused exclusively by improper installation
or use of scooters in conflict with the user manual.
Model of the scooter:
Serial number of the frame:
Date of sale:
Vendor:
Stamp and signature:
Úvod
Montáž, seřízení a pravidelnou údržbu doporučujeme svěřit
odbornému cykloservisu. Neodborné zásahy mohou vést
k poškození koloběžky či nehodě s vážnými zdravotními následky.
Pokud jste ale technicky zdatní, ničeho se nebojte a s chutí
se do montáže pusťte s námi.
Dotazy, připomínky a náměty na zlepšení našich výrobků
nám prosím posílejte na e-mail: info@yedoo.cz.
Více informací ze světa
koloběžek a seznam distributorů
najdete na www.yedoo.cz
10 11
CZ