Mounting To Concrete Or Brick Wall - Welch Allyn LS200 Manuel De L'utilisateur

9. Carefully remove LS200 arm/luminaire
assembly from box. Complete transformer
mounting according to steps 5 and 6 of
instructions on page 8.
10. Place arm/luminaire assembly on exten-
sion arm by sliding universal connector (B)
onto extension arm (G) and aligning screw
holes.
11. Insert 0.5" (13mm) flathead screw (b) into
hole on side of universal connector and
tighten. Move arm up and down to check
that mounting is secure.
12. Push cord into clips in underside of extension arm.

Mounting to concrete or brick wall:

1. Remove wall mount assembly and hardware kit from box.
CAUTION: DO NOT use the center two holes in the
wall plate for concrete walls. Additional holes must
be drilled for masonry surface mounting to assure
durable attachment.
2. Drill holes in wall plate:
a. Place wall plate flat on a wooden surface which can be
drilled into.
b. Mark four holes on wall plate 1" (2.5cm) from each edge
in corners of plate.
c. Use a center punch to start holes.
d. Drill four holes using a 13/64" (5.1mm) drill bit.
3. Select mounting location on wall that is within 8' (2.4m) of
electrical outlet.
4. Using wall plate as a template, place on selected location on
wall and mark upper-left hole.
1" (2.54 cm)
1"
(2.54 cm)
MASONRY HOLES
ARM/
LUMINAIRE
ASSEMBLY
UNIVERSAL
CONNECTOR (B)
MASONRY HOLES
6
(b)
EXTENSION
ARM (G)