Welch Allyn LS200 Manuel De L'utilisateur page 12

5. Grasp expired lamp by its base with two fingers and slide
out of lamp holder (see E).
6. Return release lever to upward position (see F).
7. Remove Welch Allyn Replacement Lamp #06400 from
its package.
8. Grasp replacement lamp between your two forefingers (see G).
NOTE: Try not to touch the inside of reflector—dirt or oil can
cause reduced light output. Clean according to instructions on
page 12, if necessary.
9. Carefully slide the lamp into the lamp holder with two fingers,
making sure the two pins on the base of the lamp slide into the
socket and the reflector slides under the spring (see H).
10. To assure proper placement in socket, gently push lamp into
socket until completely seated and snap into place (see I).
TETHER
C
E
G
10
RELEASE
LEVER
D
F
ALIGN
SPRING
H