Hot Surface - Welch Allyn LS200 Manuel De L'utilisateur

Thank you for purchasing the Welch Allyn
Light, designed by a leading worldwide manufacturer of illumi-
nated diagnostic instrumentation. By following the use and care
guidelines given in this manual, you will be rewarded with years
of dependable, trouble-free service from your new LS200
Procedure Light. Read these instructions thoroughly before use.
WARNING
!
All users of this procedure light should be thoroughly trained in the
medical procedures appropriate to the equipment. Furthermore, they
should read and understand the instructions for all other equipment
used in conjunction with the LS200™ Procedure Light.
Lamps are extremely bright. DO NOT stare directly into lamps when lit.
DO NOT position luminaire in the upward direction with the lamps on.
CAUTION
!
Remove power cord from electrical outlet and allow lamps to cool
before replacing (replace with Welch Allyn Lamp #06400 only).
Accessible metal parts of this unit are electrically isolated from the
grounding conductor of the supply cord. If grounding of the accessible
parts is considered necessary, a separate grounding lead should be
employed.
To reduce the risk of electric shock, do not disassemble unit.
Refer servicing to qualified service personnel.
CAUTION
!
Operation at closer than 12" (30.5 cm) for
extended periods may result in erythema.
The designed working distance is 24" (60 cm).
CAUTION
!
The switch on luminaire is NOT a mains switch. Transformer energizes
when the light is plugged to mains.
DANGER
!
Risk of explosion if used in the presence of flammable anesthetics.

HOT SURFACE

The bezel in front of the lamps may be hot.
® LS200
1
™ Procedure
60cm