Inserting The Batteries Into The Remote; Connect Power; Antenna Connection - Telefunken B24H340A Mode D'emploi

Changing Channels and Volume
You can change the channel and adjust the volume
by using the Volume +/- and Programme +/- buttons
on the remote.

Inserting the Batteries into the Remote

Remove the screw that secure the battery compartment
the cover gently. Insert two size AAA batteries. Make
sure the (+) and (-) signs match (observe correct
polarity). Do not mix old and new batteries. Replace
only with same or equivalent type. Place the cover back
on. Then screw the cover back on again.

Connect Power

IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow the
TV set to reach the ambient room temperature before
you connect the set to the mains. Plug the power cable
to the mains socket outlet.

Antenna Connection

Connect the aerial or cable TV plug to the AERIAL
INPUT (ANT) socket or satellite plug to the SATELLITE
INPUT (LNB) socket located on the back of the TV.
satellite
REAR
OF
THE TV
aerial
or
cable
TRADEMARK ACKNOWLEDGMENT
The terms HDMI and High-Definition Multimedia
Interface, and the HDMI Logo are trademarks or
registered trademarks of HDMI Licensing Administrator,
Inc. in the United States and other countries.
Manufactured under license from Dolby Laboratories.
Dolby, Dolby Audio and the double-D symbol are
trademarks of Dolby Laboratories.
Information for Users on Disposal of Old Equipment
and Batteries
[European Union only]
Equipment bearing these symbols should not be
disposed as general household waste.
You should look for appropriate recycling facilities and
systems for the disposal of these products.
Notice: The sign Pb below the symbol for batteries indicates
that this battery contains lead.
Battery
Products
English - 27 -
TV Broadcasting PAL B/G D/K K I/I'
VHF (BAND I/III) - UHF
Receiving Channels
(BAND U) - HYPERBAND
Fully integrated digital
terrestrial-cable-satellite
Digital Reception TV(DVB-T-C-S)
(DVB-T2, DVB-S2
compliant)
Number of Preset
10 000
Channels
Channel Indicator On Screen Display
RF Aerial Input 75 Ohm (unbalanced)
Operating Voltage 220-240V AC, 50Hz.
Audio German+Nicam Stereo
Audio Output Power
2 x 2,5 W
(WRMS.) (10% THD)
Power Consumption (W) 45 W
TV Dimensions DxLxH
134 x 554 x 370 mm
(with foot) (mm)
TV Dimensions DxLxH
35/61 x 554 x 339 mm
(without foot) (mm)
Display 24"
Operation temperature 0ºC up to 40ºC, 85%
and operation humidity humidity max
English - 28 -