Maintenance And Storage - Bestway Sierra Ridge Air Pro X6 Notice D'utilisation

Name: Sierra Ridge Air Pro X6 Tent
Model:68079
WARNING
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
Keep all flames and heat sources away from this tent fabric. We recommend that you always position your tent upwind from a camp
fire. This will reduce the chances of having embers land on your tent. In case of fire, please find the exit to escape from the fire.
Never set up the tent near a river, under a tree or other objective hazards.
This tent designed for use in mainly moderate weather conditions.
Keep exits clear.
Make sure ventilation openings are open all the time to avoid suffocation.
Set the ventilation openings to the right position and keep them locked in an upright position.
Overload may cause danger.
KEEP THE POLES INFLATABLE ENOUGH. UNDER-INFLATION MAY AFFECT TENT PERFORMANCE.
DO NOT OVER-INFLATE THE POLES. OVER-INFLATE MAY DAMAGE THE POLES.
DO NOT OPEN THE ZIPPER OF THE AIR POLES ESPECIALLY WHEN IT'S FULLY INFLATED.
Choose a suitable site removing any sharp objects, which might damage the groundsheet. Cat. B camping tent in accordance
with ISO 5912 (Performance level 1: for infrequent and short-term use. Although rain resistant, these tents should be used
mainly in fair weather.)
Outer tent: 640cm x (390cm + 110cm) x 225cm
Inner tent: 210cm x 360cm x 210cm
Pitching dimension: 840cm x 700cm
SAVE THESE INSTRUCTIONS
SETTING UP THE TENT
1. Lay the tent on the ground. Pull the four corners outwards.
2. Secure the four corners by pushing the pegs into the ground loops.
3. Inflate the tent with hand pump. The ideal inflation pressure will be around 6PSI or when the poles feel fully inflated.
4. Secure the tent with the pegs and guy ropes.
NOTE: Drawings for illustration purpose only. May not reflect actual product. Not to scale.
MAINTENANCE AND STORAGE：
1. Clean the tent and remove any stains with a sponge and cool water.
Please use non-detergent soap for serious cleaning.
2. Please allow all parts to dry thoroughly before you repack the tent.
This will prevent the formation from mould, bad odours and discolouration.
3. Replace the Pole in case of air leakage.
4. Silicone spray could be use onto zippers if stick.
5. Deflate the tent by unscrewing the screw valve.
6. Store the tent in the stuff sack and place it in a cool, dry area out of sunlight and away from heat sources and rodents.
PARTS NO.
P3046B
P5C507
P5548
F4C073B-02
P61602
P61599
P61600
P61601
F2118
P5589
P5590
P5617
S-S-006022/14.0x21.0cm/68079/JS-YF-2016-B-17656/六人充气帐篷说明书/英
OWNER'S MANUAL
NAME
High pressure pump
Pressure Gauge
Peg
Screw Valve
Tent
AIRFRAME Pole (660cm + 151cm Red mark on the end)
TM
AIRFRAME Pole (660cm + 131cm Blue mark on the end )
TM
AIRFRAME Pole (600cm Yellow mark on the end)
TM
Guy Rope (Φ 3.8mm X 350cm)
Steel Pole (Φ 16mm X 180cm)
Fiber Glass Pole (Φ 9.5mm X 420cm)
Big peg
4
QTY
1
1
36
4
1
2
1
1
2
2
1
4