Clarity AlertMaster AL10 Mode D'emploi page 14

Regulatory Compliance
The telephone company may make changes in its facilities, equipment,
operations or procedures that could affect the operation of the
equipment. If this happens, the telephone company will provide advance
notice in order for you to make necessary modifications to maintain
uninterrupted service.
If trouble is experienced with this telephone equipment, for repair
or warranty information, please contact Clarity, 800-426-3738. If the
equipment is causing harm to the telephone network, the telephone
company may request that you disconnect the equipment until the
problem is resolved.
This telephone equipment is not intended to be repaired and it contains
no repairable parts. Opening the equipment or any attempt to perform
repairs will void the warranty. For service or repairs, call 800-426-3738.
Connection to party line service is subject to state tariffs. Contact the
state public utility commission, public service commission or corporation
commission for information.
If your home has specially wired alarm equipment connected to the
telephone line, ensure the installation of this telephone equipment does
not disable your alarm equipment. If you have questions about what will
disable alarm equipment, consult your telephone company or a qualified
installer.
This telephone equipment is hearing aid compatible.
Customer-Owned Coin/Credit Card Phones
To comply with state tariffs, the telephone company must be given
notification prior to connection. In some states, the state public utility
commission, public service commission or corporation commission must
give prior approval of connection.
25
Regulatory Compliance
PART 15 OF FCC RULES INFORMATION
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Your AL10 Notification System has been tested and found to
comply with the limits of a Class B digital device, pursuant to Part 15 of
FCC rules. These limits are designed to provide reasonable protection
against harmful interference in residential installation.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation;
if this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, you are encouraged to try to correct the interference by one of the
following measures:
1. Where it can be done safely, reorient the receiving television or radio
antenna.
2. To the extent possible, relocate the television, radio or other receiver
with respect to the telephone equipment. (This increases the separation
between the telephone equipment and the receiver.)
3. Connect the telephone equipment into an outlet on a circuit difference
from that to which the television, radio, or other receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
WARNING: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user's authority
to operate the equipment.
E
N
G
L
I
S
H
26